Introduction; Assembly - Rotel U485CH1 Mode D'emploi

 INTRODUCTION
o
This appliance is equipped with a thermostat system. This system will automatically
cut off the power supply to the appliance in case of overheating.
o
If your appliance suddenly stops running:
 Pull the mains plug out of the socket.
 Press the switch to turn off the appliance.
 Let the appliance cool down for 60 minutes.
 Put the mains plug in the socket.
 Switch the appliance on again.
o
Switch off the appliance and disconnect from supply before changing accessories or
approaching parts that move in use.
o
If plugged in, the indictor light will be on.
o
CAUTION: In order to avoid a hazardous situation, this appliance must never be con-
nected to a time switch.
 ASSEMBLY
o
Hold the head and insert it into the inlet (when in-
serting please ensure that the feeding tube is in
vertical position, see fig.1). Then push the locking
handle into the vertical position (fig.2).
o
Place the worm into the head, long end first, and
turn to feed the screw slightly until it is set into the
motor housing (fig.3).
o
Place the cutting blade onto the worm shaft with
the blade facing the front, as illustrated (fig.4). If it
is not fitted properly, the meat will not be ground.
o
Place the desired cutting plate next to the cutting
blade, fitting the protrusions into the slot (fig.5).
o
Support or press the center of the cutting plate
with one finger then screw the fixing ring tight with
the other hand (fig.6). Do not over-tighten.
o
Place the hopper plate on the head and fix it into
position.
o
Locate the unit on a firm surface.
o
The air passage at the bottom and the side of the motor housing should be kept free
and not blocked.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instructions for use
33