Technical Specifications; Floor Load; Water Composition; Working Clearance - AO Smith IT-1500 Notice D'installation, Mode D'emploi, Notice D'entretien

1

1.1 Floor load

1.2 Water composition

1.3 Working clearance

1.4 General
specifications
Contents
Empty weight
Max. floor load
Max. operating pres. tank
Max. operating pres. heat exchanger
Max. water temp. tank
Max. water temp. heat exchanger
Anodes
Capacity heat exchanger
Primary flow 80/60ºC
Pressure loss
Heat exchange surface
IT 1500 / 2000 / 2500 / 3000

Technical specifications

Allow for the water heater's weight and the maximum floor load; refer to the table
"General specifications").
The water heater is intended for heating drinking water. The drinking water must comply with
the regulations governing drinking water for human consumption. The table gives an
overview of the specifications.
Water specifications
Water composition
Hardness
(alkaline earth ions)
Conductivity
Acidity (pH value)
Note
If the water specifications deviate from those stated in the table, then the tank protection
cannot be guaranteed (4"Warranty").
For access to the water heater, it is recommended that the following clearances are
observed:
around the anode connection: 100 cm.
•
around the water heater: 50 cm.
•
top of the water heater: 50 cm
•
> 1,00 mmol/l:
• German hardness > 5,6 ° dH
• French hardness > 10,0 ° fH
• English hardness > 7,0 ° eH
• > 100 mg/l CaCO
> 125 µS/cm
7,0 < pH value < 9,5
Unit IT 1500 IT 2000
litres 1550 1800
kg 398 426
kg 1948 2226
kPa (bar) 800 (8) 800 (8)
kPa (bar) 600 (6) 600 (6)
ºC 85 85
ºC 90 90
- 3 3
kW 147 147
l/h 6485 6485
mbar 830 830
2
m 5,2 5,2
(1.4
3
IT 2500 IT 3000
2550 2800
576 600
3126 3400
800 (8) 800 (8)
600 (6) 600 (6)
85 85
90 90
3 3
156 156
6871 6871
695 695
6,0 6,0
23