KOBE Brillia Série Manuel D'installation Et Mode D'emploi page 10

Preparation before Installation
-
Temporarily wire the hood to test for proper
operation before installing. If the hood does
not operate, check the circuit breaker or
house fuse. If the hood is still not working,
disconnect power supply and check the
continuity of all wire connections.
-
Peel protective film off the hood (if any).
-
For installing under the cabinet with recessed
bottom, attach 4-inch wide wood filler strips (not
included) on each side. (Figure 1)
-
Using reference on Page 15 to measure and
create access opening for electrical wires and
exhaust under the cabinet.
Hood Installation
CAUTION
: If moving the cooking range is
necessary to install the hood, turn off the power
in an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE. And use a protective covering to
protect cooktop
damage.
1. Remove the bottom
filters/stainless steel spacers if necessary;
arrange the electrical wires to run through the
1" diameter hole on the top or the rear of the
hood.
2. Using references
measurements on page 15, center the hood in
place beneath the cabinet and flush with the
front of the cabinet.
3. Draw electrical wires through cabinet access
opening.
4. Use electrical drill to remove the knockout holes
on top of the range hood.
5. Place screw (provided) into the exact center of
each knockout hole. Make sure all screws are
in place before tightening screws.
CAUTION
: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
UNDER CABINET INSTALLATION
and/or countertop
casing or
on Table 1
Figure 1
from
baffle
and
8