Maintenance And Cleaning; What To Do In Case Of A Problem - CONTINENTAL EDISON CECP502RP Notice D'utilisation

MAINTENANCE AND CLEANING

Switch-off the appliance before cleaning.
Do not clean the hob if the glass is too hot because they are risk of burn.
 Remove light marks with a damp cloth with washing up liquid diluted in a little water. Then
rinse with cold water and dry the surface thoroughly.
 Highly corrosive or abrasive detergents and cleaning equipment likely to cause scratches
must be absolutely avoided.
 Do not ever use any steam-driven or pressure appliance.
 Do not use any object that may scratch the ceramic glass.
 Ensure that the pan is dry and clean. Ensure that there are no grains of dust on your
ceramic hob or on the pan. Sliding rough saucepans will scratch the surface.
 Spillages of sugar, jam, jelly, etc. must be removed immediately. You will thus prevent the
surface being damaged.

WHAT TO DO IN CASE OF A PROBLEM

When the symbol [ E 4 ] appears :
I) The table must be reconfigured. Please implement the following steps:
Important : before you start:
 make sure there is no more pot on the hob
 take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
 disconnect the appliance from the grid by removing the fuse or turning the circuit
breaker off
 start the procedure within 2 minutes after reconnecting the hob to the grid
 reconnect the table to the grid
 don't use the [ 0/I ] touch
II) First step : cancel the existing configuration
1) Press [ - ] and hold down
2) With your other hand, press successively
and quickly (less than 2s) on each [ O ] key.
Press 2 times each key in the following order
(a -> a -> b -> b). [ - ] appears on displays.
A double "beep" means an error occurred.
If so, start again from item 1).
3) Remove your fingers from the touch control, press simultaneously [ + ] and [ - ]
during few seconds, until blinking [ E ] symbols appear.
4) Wait until [ E ] symbols stop blinking.
5) After few seconds, [ E ] are automatically transformed in [ C ]. The existing setup
has been cancelled.
Note: For induction hobs with 3 cooking zones, The rear right zone (b) doesn't
exist, so push 2 times on the front right zone (a) that means (a → a → c → d).
III) Second step: new setup
1) Take a ferromagnetical pot with a minimum diameter of 16 cm
2) Select a cooking zone by pushing on the corresponding [ O ] key
3) Place the pot on the area to be set
4) Wait until the [ C ] display becomes a [ - ]. The selected zone is now configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6) All the cooking zones are configured once all the displays are turned off.
Please use the same pot for the whole procedure.
Never put several pots together on the zones during the setup-process.
 If [ E 4 ] displaying remains, please call the customer care
23
b a