Elem Garden Technic WTTAC51T-CC196-CMES Traduction Des Instructions D'origine page 104

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Engine Maintenance
Check Engine Oil Level
Check the engine oil level with the engine stopped and the
mower.
Remove the oil filler cap, and wipe the dipstick clean.
Insert the dipstick into the oil filler neck, but do not screw it
in.
Check the oil level shown on the dipstick. If near the lower,
fill to the upper level with the oil. Do not overfill.
Screw in the filler cap securely.
NOTICE: Running the engine with a low oil level will cause
engine damage.
Oil tank : 0.6L SAE 15W-40
Change Engine Oil
Drain the used oil while the engine is warm. Warm oil drains quickly and
completely.
Wipe the oil filler area clean, then remove the oil filler cap/dipstick.
Place a suitable container next to the mower to catch the used oil, then tilt the
mower on its right side. The used oil will drain through the filler neck. Allow the oil
to drain completely.
Please dispose of used motor oil and the containers in a manner that is compatible
with the environment. We suggest you take it in a sealed container to your local
recycling center or service station for reclamation. Do not throw it in the trash, pour
it on the ground, or pour it down a drain.
Fill with the recommended oil. Do not overfill. Allow a couple of minutes for the oil
to settle in the engine, then measure the oil level.
104

Publicité

Table des Matières
loading

Table des Matières