Manuels Connexes pour Alt BATON ROUGE 25721
Sommaire des Matières pour Alt BATON ROUGE 25721
- Page 1 BATON R O UGE #25721 Pressure balance trim kit with cartridge and handle Garniture pour valve à pression équilibrée avec cartouche et poignée Installation & care guide Guide d’installation et d’entretien last revision: 15/03/2021...
- Page 2 Félicitations pour l’achat de purchase of your Alt product votre produit Alt By purchasing an Alt product, you are taking part in En achetant un produit Alt, vous prenez part au the global movement for better living. We take pride in mouvement global pour le mieux-vivre.
- Page 3 TRIM KIT COMPONENTS COMPOSANTES DE LA GARNITURE SPECS AT LARGE / SCHÉMA DES PIÈCES 1 ALT7-25-774-01: handle / poignée 2 ALT7-25-650-01: trim plate+screw / plaque+vis 3 ALT7-CTCB-0185-01: Dome cap / Capuchon en dôme 4 ALT7-60-699-00: cartridge / cartouche...
- Page 4 BEFORE YOU START AVANT DE COMMENCER CAUTION: FOR BEST RESULTS, WE STRONGLY REC- MISE EN GARDE: POUR OBTENIR UN RÉSULTAT OMMEND THE INSTALLATION OF THIS VALVE BE DONE OPTIMAL, NOUS RECOMMANDONS FORTEMENT QUE BY A LICENSED PLUMBER. L’INSTALLATION DE CETTE VALVE SOIT FAITE PAR UN PLOMBIER ACCRÉDITÉ.
- Page 5 INSTALLATION Installing the cartridge First, verify the 2 check-valves (1) & (2) are shut off. Afterwards, unscrew the cartridge holder (4) and re- move the protective plug (3) (see Fig.1) . Insert the cartridge into the valve body as shown (Fig.2). Screw the cartridge holder (4) back into place.
- Page 6 INSTALLATION Installing the trim kit Insert the decorative sleeve (6) onto the cartridge holder (See Fig.3) then screw the dome cap (7) onto the valve body. Slide in trim around the valve body and press it firmly against the wall. Make sure the trim is properly aligned with red marking (HOT water) on the left and blue marking (COLD water) on the right.
- Page 7 INSTALLATION Water temperature adjustment The preset temperature can be adjusted by following these steps: Remove the setscrew (1), the volume control handle (2) and the dome cap (3). (See Fig.4). Pull out the temperature stop ring (4) from the cartridge (5).
- Page 8 MAINTENANCE To Service The Cartridge Remove all the components from (1) to (7). (See Fig.5). Afterwards, shut off the 2 check valves (10) & (11) by turning them clockwise with a screwdriver. Unscrew the cartridge holder (8) and remove the cartridge (9). To clean the cartridge, you may need to soak it in a vinegar and water solution to remove lime build-up.
- Page 9 CARE SOIN To clean your ALT faucet or accessory, wash with a Pour nettoyer et conserver l’apparence de vos wet nonabrasive soapy cloth. Then wipe dry with a robinets ou accesoires ALT, lavez-les avec un linge soft towel or cloth. We recommend this be done on mouillé...
- Page 10 - Any and all ALT products that are subjected to any type of harsh de produits abrasifs, de corrosion et/ou d’accidents causés par un abrasive, such as cleaners containing abrasive cleansers, ammonia, professionnel ou par toute autre personne.