Preparing For Use; Transport And Storage; Assembly - Sigel Workplace Instructions De Montage Et D'emploi

Preparing for use

Transport and storage

4 Preparing for use
4.1 Transport and storage
Please note the following when transporting the "Workplace" office caddy::
Check the packaging for damage if you have ordered the "Workplace" office caddy through a
ƒ
retailer. Report any damage during shipment to the transportation services provider and to the
retailer from whom you purchased the "Workplace" office caddy.
Two people are required to carry the "Workplace" office caddy. If necessary, use a trolley to
ƒ
transport the caddy.
During transport and when storing the product, do not knock, drop or otherwise apply force.
ƒ
This can damage the "Workplace" office caddy.
During transport, do not expose the "Workplace" office caddy to moisture or extreme
ƒ
temperatures, e.g. frost or heat.
Please note the following when storing the "Workplace" office caddy:
Store the "Workplace" office caddy in its original packaging for as long as possible. If you no
ƒ
longer have the original packaging, keep the office caddy covered during storage.
Store the "Workplace" office caddy in a dry, enclosed space to protect it from moisture, direct
ƒ
sunlight, dust and dirt.
4.2

Assembly

Note
`
Fig. 3 Assembly steps
The one-sided "Workplace" office caddy upgraded to a two-sided caddy as follows:
1. Place a cloth on a slightly raised surface and put the "Workplace" office caddy on top of it
while upgrading. This prevents the office caddy from being damaged or scratched.
2. Unpack the components of the add-on set. Dispose of the packaging properly, recycling it
where possible.
3. Place the one-sided "Workplace" office caddy on the cloth.
4. Loosen the 4 M10 screws (no. 3) with the larger of the enclosed hex keys (no. 5) and remove
them along with the 4 grommets.
5. Remove the short foot of the one-sided "Workplace" office caddy.
Further information can be found under point 7 "Disassembly".
6. Align the short side of the long foot (no. 1) with the long foot already attached to the caddy
(see fig. 3).
7. Tighten the 4 grommets and the 4 M10 screws (no. 4) using the larger of the enclosed hex
keys (no. 6).
Office Caddy Workplace
We recommend that the product is assembled by a qualified person, such as your
company's facility manager.
17