Turning Power On/Off - Sharp PN-Y555 Manuel D'installation

Caution
• Turn on the monitor first before turning on the PC or
playback device.
Turning on the main power
When the main power is turned on, the power LED lights. Wait
until the screen is displayed.
Main power switch
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
Risk of failure or malfunctioning if the interval is too short.
• For a complete electrical disconnection, pull out the main
plug.

Turning power on/off

Press the POWER button to turn the power ON/OFF.
POWER button
Status
Green lit Power on
Orange lit Power off (Standby mode)
Green flashing Input signal waiting mode
Turning Power On/Off
nOperation mode
When the monitor is turned on for the first time after being
shipped from the factory, the operation mode setting screen
will be displayed. Set it to MODE1 or MODE2.
MODE1 ... OFF IF NO OPERATION is set to ON, and
MODE2 ... Will perform standard operation.
Even after being set, changes can be made using
OPERATION MODE, located in the menu of the monitor. (See
OPERATION MANUAL.)
nDate/time setting
• If the time has not been set, such as when the monitor
•
•
Power LED
Status of the monitor
STANDBY MODE is set to LOW POWER. (These
settings can not be changed.)
If there is no operation for 4 hours or more, the
monitor automatically enters standby mode. Power
consumption in standby mode is also minimized.
OFF IF NO OPERATION is set to OFF, and
STANDBY MODE is set to STANDARD. These
settings can be changed.
is first turned on, set the date and time in DATE/TIME
SETTING of the SETUP menu.
Be sure to set the date and time.
TIPS
Set the time on a 24-hour basis.
The clock stops if the main power remains off for about 1
week.*
(* Approximate time. The actual time varies depending
on the state of the monitor.)
7
E