ION Vinyl Motion Guide D'utilisation page 3

Features
1. Platter – Place
record here.
2. 45 RPM Adapter Holder
– Holds the included 45
RPM adapter. When not
using the adapter, please
place it in this holder.
3. Tonearm – The
tonearm can be raised
and lowered by hand, or
by pressing the raise /
lower lever.
4. Arm Clip – This specially
designed arm clip secures
the tonearm while at rest
or when not in use. The
arm clip has
designed to remain in the
up position
unlocked.
5. Raise / Lower Lever –
Raises and lowers the tonearm.
6. 33 / 45 / 78 Switch – This switch controls the RPM of
the turntable platter.
Note: For best results when playing 78 RPM vinyl
records, use a 78 stylus (sold separately). Only use a
78 stylus with 78 RPM vinyl records. Purchase the
iCT06rs 78 stylus at ionaudio.com/ict06rs.
7. Autostop switch – This switch turns autostop on or
off. When autostop is on, the platter will start spinning
when the tonearm is placed over the record and stop
spinning when the record has reached the end. (When
autostop is off, the platter will always spin regardless
of the position of the tonearm.)
Note: If your vinyl record stops before it reaches the
end of the music, turn Autostop to the off position for this particular
record. This is generally recommended for 45 RPM records.
8. Volume/Power Knob – To power on Vinyl Motion, turn this knob
clockwise until it clicks. When powered on, use this knob to adjust the
volume for the internal speakers and headphones. To turn off Vinyl
Motion, turn this knob counterclockwise until it clicks.
9. Headphone Output – Connect headphones here (sold separately) to listen to your vinyl.
10. Battery Charging Indicator – The LED will illuminate when charging the battery. The LED will turn off
once the battery is fully charged.
11. Power Indicator – This LED illuminates when the power is on and goes out when the battery power is
depleted.
12. Speaker – The record's audio will be played through this built-in speaker.
13. Aux Input – Connect a CD player, digital media player, or other audio source to this 1/8" stereo
auxiliary input.
14. RCA Output* – The audio from a playing vinyl record is sent to this line-level coaxial audio output. This
must not be connected to phono level devices.
15. USB Port – Use the included USB cable to connect your turntable to your computer. The USB
connection will send audio from the turntable to your computer. Please see the Using Vinyl Motion
With Your Computer section of this manual for information. Also, use the included USB cable to
connect Vinyl Motion to a USB power adapter connected to a power outlet or your computer.
your
fixed
been
while
12
1
IMPORTANT: Place the included felt slipmat
on the platter; then place your record on the
felt slipmat to carefully hold your records.
IMPORTANT: Remove the plastic cartridge
cover (needle cover) before operating the
turntable.
*WARNING: The RCA outputs are LINE level.
Please only connect these to LINE level
inputs. You may damage your receiver if you
plug in a LINE level device into a PHONO
level input.
3
3
2
4
5
6
33
45
78
7
AUTO
STOP
OFF
ON
12
14 15
13
8
10
11
9