Assembly Instructions - BEAL YB55T Notice D'emploi

Never use the machine after drinking alcohol.
The factory-fitted control units, such as the gear cable from the handle, must not
be removed or covered.
Always check that nuts and bolts are tight before starting the machine.
When the engine is running, do not pull the handle for forward gear and the
handle for reverse at the same time! This will damage the transmission. Always
release one handle before the other is used.
Using the machine on steep slopes is dangerous!

Assembly instructions

1. Figure 1 shows the contents of the kit:
a. Blades
b. Tiller with cables
c. Support wheel
d. Side guards
e. Upper handlebar
f. Bracket for starter handle
g. Depth skid
h. Lower handlebars, right and left
i. Mounting bracket for steer
j. User manual
2. Figure 2.
Mount support wheel.
Remove bracket(a). The levers on the bracket must go behind the rear axle.
Mount the bracket over the rear axle to attach the support wheel.
3. Figure 3.
Mount the two lower handlebars with the bolts supplied (c,d). Note that the left and
right handlebars are different.
Steer (a.) must be mounted on the right. Steer (b.) must be mounted on the left.
4. Figure 4,5.
Mount upper handlebar using the bolts supplied and the hand wheel
Note the arrows on the plastic brackets. They must be aligned when mounting.
5. Figure 6, 7, 8
Mount throttle cable (a.) and clutch cables (b.) as shown on the picture.
6. Figure 10 + 15A
Mount the blades using the cotter bolts and pins.
"Be careful of rotating knives"
Only use the machine in areas where it can be
operated safely!
10