Multiplex HFMG4 M-LINK Mode D'emploi page 15

15. F R
AST ESPONSE
In Fast Response mode, which operates at the ultra-rapid pulse
rate of 14 ms, up to twelve servo channels are available. This
reduced pulse rate can cause analogue servos to oscillate or run
jerkily.
If this is the case, or if you wish to use up to the maximum
sixteen servo channels, it is possible to switch Fast Response
mode OFF; in this case the servo frame rate reverts to 21 ms.
This is the procedure for switching Fast Response ON and OFF
with the Graupner mc-32 with 2.4 GHz M-LINK technology:
1. Switch the RC system OFF, open the transmitter, and
disconnect the transmitter battery ( 2.).
2. Locate the lower of the two switches (switch 2 = Fast
Response) on the 2.4 GHz HFMG4 M-LINK RF module:
 Switch 2 "Fast Response" to the right (ON position)
= Operating mode "Fast Response ON".
 Switch 2 "Fast Response" to the left
= Operating mode "Fast Response Off".
Default setting
= Operating mode "Fast Response mode OFF".
!
Caution: always use a small screwdriver to move the
switch; never use a pencil!
3. Connect the transmitter battery ( 2.), close the transmitter.
5. If you change the Fast Response mode setting (enable /
disable), you must then repeat the binding procedure for the
transmitter and receiver ( 11.)!
Operating Instructions
HFMG4 M-LINK 2.4 GHz RF Module
ON / OFF
16. O
PERATING THE
RF
MODULE WITH RESTRICTED FREQUENCY
RANGE
In particular countries the M-LINK system must not be used
without activating the reduced frequency range approved in that
region ( 6.). For an overview of the countries concerned
please refer to the separate sheet entitled "Operating the 2.4
GHz M-LINK system with restricted frequency range".
This is the procedure for activating (or disabling) the restricted
frequency range:
1. Switch the RC system OFF, open the transmitter, and
disconnect the transmitter battery ( 2.).
2. Locate the upper of the two switches (switch 1 = France) on
the 2.4 GHz HFMG4 M-LINK RF module:
 Switch 1 "France" to the right (ON position)
= Operating mode "Restricted frequency range ON".
 Switch 1 "France" to the left
= Operating mode "Restricted frequency range OFF".
Default setting
= Operating mode "Restricted frequency range OFF".
!
Caution: always use a small screwdriver to move the
switch; never use a pencil!
3. Connect the transmitter battery ( 2.), close the transmitter.
4. If you change this operating mode, you must then repeat the
binding procedure with all the receivers you wish to use with
the transmitter ( 12.)!
Page 15
HFMG4 M-LINK 2.4 GH
Z