Bosch PST 900 PEL Notice Originale page 24

OBJ_BUCH-1053-001.book Page 24 Tuesday, September 29, 2009 8:16 AM
24 | English
Attaching "Cut Control" to the Base Plate
(see figure D)
Clamp the "Cut Control" 12 viewing window in-
to the holders of the base 13. Then, lightly press
the base together and allow it to engage into the
lead 23 of the base plate 7.
Attaching "Cut Control" to the Sliding Shoe
(PST 1000 PEL) (see figure E)
With this cutting-line control system, the "Cut
Control" viewing window 12 can either be fas-
tened together with the base 13 to the base
plate 7 or separate, directly in the holder of the
sliding shoe 11.
Remove the "Cut Control" base 13 from base
plate 7. For this, lightly press the base together
and remove it from the guide 23.
Pull off the "Cut Control" viewing window 12
from base 13 and clamp it into the holders on
the sliding shoe 11.
Dust/Chip Extraction
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
2 609 003 953 | (29.9.09)
Dust Cover (see figure F)
Mount the dust cover 10 before connecting the
machine to the dust extraction.
Mount the dust cover 10 to the machine in such
a manner that the prongs engage into the open-
ings of the housing.
Remove the dust cover 10 for applications with-
out dust extraction as well as when performing
mitre cuts. For this, push the dust cover togeth-
er at the two outer holders and pull it off toward
the front.
Connecting the Dust Extraction
Place a vacuum hose 4 (accessory) onto the vac-
uum connection 5. Connect the vacuum hose 4
with a vacuum cleaner (accessory). An overview
for the connection of various vacuum cleaners
can be found at the end of these instructions.
Switch the saw dust blower off when a dust ex-
traction system is connected (see "Sawdust
Blower Device").
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Bosch Power Tools