Publicité
Les langues disponibles
Les langues disponibles
22 • English
14 • English
• Only insert the mains plug when the appliance is switched off.
• Only specialists are allowed to do reparations. Improperly reparations
can cause considerable danger!
• There is always risk of injury when using electrical appliances
improperly!
• To prevent unintentional misuse, keep the appliance stored away
in a safe place.
Safety instructions when operating the appliance
• Always use the appliance for the appropriate purpose!
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
• Keep packaging material e.g. plastic bags out of the reach of
children!
Warning! Risk of electric shock
• Never use the appliance with wet hands, in the bath or shower
or over a filled washbasin. If the appliance falls into water,
remove the mains plug immediately. Under no circumstances
reach into the water when the appliance is still connected to the
power supply!
Warning! Risk of electric shock
• When the appliance is used in a bathroom, unplug it after use
since the proximity of water presents a hazard even when the
appliance is switched off!
• Never put the appliance on soft cushions or blankets during
operation!
• Do not place the appliance or the connecting cable on hot
surfaces e.g. cooker or similar or in the vicinity of open flames!
• To avoid damaging of the hair the air outlet should not be too
close to the hair!
• Do not cover the air intake or air outlet during use!
• Make sure that you switch off the appliance when not in
continuous use!
• The appliance is fitted with an overload protection which
switches off in the case of an overload (e.g. air outlet or intake
is blocked). If the appliance switches off during use, please reset
the graduated switch to "0" and wait for approx. 5 minutes.
Then, switch on again!
Publicité
