Evolite ArchiTECH 150 Mode D'emploi page 19

o Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy
troubleshooting:

The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.

Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and
polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
fixture or the previous one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.

Some fixtures don't respond to the easy controller
o
You may have a break in the DMX cabling.
o
Check the LED for the response of the master/ slave mode signal.

No response to the sound
o
Make sure the fixture does not receive DMX signal.
o
Check microphone to see if it is good by tapping the microphone.

Technical Specifications
Model
Voltage
Power consumption:
LED
Weight
Dimensions
ArchiTECH 150 Manual Ver. 1.00
ArchiTECH 150
110V- 250V / 50-60Hz
270W
30 pcs 5 Watts RGB 3 in 1
5 kg
231 x 170 x 236 mm
DMX
19
Page