Makita DCS460 Manuel D'emploi Et De Sécurité page 13

1
2
2
= cutting down area
When felling, maintain a distance of at least 2 /2 tree
lengths from the nearest person (see fig. 17).
Note:
The noise of your engine may drown any warning call.
Felling instructions:
First clear the tree base and work area from inter-
fering limbs and brush and clean its lower portion an
axe (see fig. 18).
Then, establish a path of escape and remove all obsta-
cles. This path should be opposite to the planned
direction of the fall of the tree and at a 45° angle (fig.
9). An alternate path must also be selected. Place
all tools and equipment a safe distance away from the
tree, but not on the escape path.
45°
45°
7
8
45°
9
First cut
If the tree has large buttress roots, cut into the largest
buttresses vertically first (horizontally next) and remove
(fig. 20).
Felling cut
Felling notch
Then, determine the placement of the felling notch
(fig. 21). The felling notch when properly placed de-
termines the direction in which the tree will fall. It is
made perpendicular to the line of fall and should be as
close to the ground as possible. Cut the felling notch
to a depth of about one-fifth to one-fourth of the trunk
diameter (fig. 22). It should be in no case higher than
it is deep. Make the felling notch very carefully.
Second cut
20
Direction of fall
2
Hinge
Felling notch
22
Hinge
23
3