Control; Control Panel - Parker 200 Manuel D'utilisation

5

Control

5.1 Control panel

1
&
1 MAIN SWITCH
;
2 MAINTENANCE LED
(
3 WARNING LED
)
4 DEW POINT LED
*
5 DRAIN LED
+
6 DRAIN BOTTON
English
2
3
4 5
I ON = dryer operating; O OFF = dryer off
Scheduled maintenance
Flashing = Dew point too low
Fixed = Dew point too high
Flashing = Dew point slightly high
Fixed = Dew point correct
Drain open
Drain opening control
200
5.2 Operation
Scheduled maintenance
;
!
When comes on, contact authorized assistance personnel for
carrying out scheduled maintenance
;
+
Press so that switches off for 24 hours.
Condensate drain
There are two operating modes:
a) TIMED - with draining at fi xed intervals (2 minutes) and settable time
(1-10 seconds);
b) EXTERNAL: - if there is an external drain.
To change operating mode, switch the unit off, keep pressed
switch the machine on at the same time.
*
In EXTERNAL mode is always on.
6
Set mode b) only in absence of the solenoid valve: otherwise
!
the relative coil could be come damaged.
*
In TIMED mode, during draining
equal to the set time. For manual opening of the drain, press .
To change the draining time, keep pressed
+
Release and press again only once within 2 seconds.
fl ash once every second for 10 seconds. During fl ashing, press
once to stop and store the count of seconds equal to the required drain-
ing time.
A relay "KA1" supplies a signal as shown in 8.8 of a high dew point
alarm.
Remote alarm (option)
A relay "KA1" supplies a signal as shown in 8.8 of a high dew point
alarm.
+
and
fl ashes for a number of seconds
+
;
+
until comes on.
*
will
+
3/6