To Fit Your Car Seat Rearward Facing For Group 1 (Isofix Only) (9Kg To 18Kg / Approx. 9 Months To 4 Years) - Hauck Varioguard Plus Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
Bring the harness connectors together and insert into the buckle
until you hear a "click" (43).
Tighten the harness by pulling on the harness adjustment strap
(44), once tight make sure that there is no more than a fingers
width between the harness and your child.
The child's head should sit directly in the middle of the headrest
and the sides of the headrest should sit just above the child's
shoulders, and the shoulder straps should be level with or below
your child's shoulders (41). If this is not the case please refer to
section 'Headrest and Safety Harness Adjustment'.
CHECKLIST
WARNING! A CORRECTLY ADJUSTED HARNESS IS
ESSENTIAL FOR YOUR CHILD'S PROTECTION. THERE
SHOULD NOT BE MORE THAN A FINGERS WIDTH BETWEEN
THE HARNESS AND YOUR CHILD.
However safe a child seat is, however well built it is, your child's
safety depends on you carrying out the following checks before
every journey.
-
Set the harness correctly and to the correct shoulder
height (38-44)!
-
Ensure the harness straps are not twisted!
-
Check the harness is set for the clothing and not loose!
-
Ensure the seat liner is suitable for the weight and age of your
child!
-
Check the harness is secure with the buckle and shoulder strap
connectors latched together and harness tension is correct
(43,44)!
-
Check the car seat is facing rearwards in the vehicle (28) and in
the fully reclined position!
IMPORTANT! Misusing your child car seat will reduce the
protection and safety you offer your child.
To fit your car seat
REARWARD FACING FOR GROUP 1 (ISOFIX only)
(9kg to 18kg / approx. 9 months to 4 years)
Firstly you must install the car seat base into your vehicle using
the ISOFIX-points. See section 'Installing the base - using the
GB
33

Publicité

Table des Matières
loading

Table des Matières