Hauck Varioguard Plus Mode D'emploi page 31

Squeeze together the ISOFIX adjustment buttons (R) located on
either side of the support leg at the front of the car seat base, and
push the support leg towards the seat base to extend the isofix
attachment points (24).
Line the isofix attachment points with the isofix latches in the
vehicle seat (25), and push the isofix points into the isofix latches
until you hear a "click".
When the isofix points are correctly attached, the isofix connection
indicators (S) will turn green (26) if the indicators remain red you
must release and re-connect the isofix points, to do this see
section "REMOVING THE BASE - when attached to the ISOFIX
points".
Once the isofix points are correctly attached, push the base
towards the vehicle seat backrest until firm (27).
IMPORTANT! Always use the support leg when the car seat base
is fitted into the vehicle.
WARNING! ENSURE THAT AT ALL TIMES THE SUPPORT
LEG IS IN CONTACT WITH THE FLOOR OF THE VEHICLE
AND THE INDICATORS ARE GREEN.
To adjust the support leg, pull the support leg adjustment button
(T) located on the back of the support leg and move the foot of the
support leg downwards until it reaches the vehicle floor (10).
When the support leg is locked into position your will hear a "click"
(10).
IMPORTANT! Make sure that the support leg indicator (V) is
green. If the indicator is red you must re-adjust the support leg.
CHECKLIST
To ensure the optimum safety of your child, check the following
after installation:
- Check that the isofix points are securely attached to thevehicle by
checking that the indicators on the isofix points (S) are green
(26)!
- Check that the support leg is fully folded out (3), that the lower
part of the leg is locked into position and the indicator on the foot
of the support leg is green (10)!
- Check that the car seat base is installed securely and firmly in the
GB
31