Installation Instructions - GE AEQ10 Série Manuel D'utilisation Et Instructions D'installation

installation
instructions
Questions? Call 800.ge.CAReS (800.432.2737) or visit our Website at: geAppliances.com
in Canada, call 1.800.561.3344 or visit www.geAppliances.ca
BefoRe You Begin
Read these instructions completely
and carefully.
iMPoRTAnT
•
— Save these
instructions for local inspector's use.
iMPoRTAnT
•
— Observe all
governing codes and ordinances.
• note to installer – Be sure to leave these
instructions with the Consumer.
• note to Consumer – Keep these instructions for
future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills .
• Completion time – Approximately 1 hour
• We recommend that two people install
this product.
• Proper installation is the responsibility of the
installer .
• Product failure due to improper installation is not
covered under the Warranty .
• Y ou MUST use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner .
eLeCTRiCAL ReQuiReMenTS
Some models require a 115/120-volt AC,
60-Hz grounded outlet protected with a
15-amp time-delay fuse or circuit breaker .
The 3-prong grounding plug minimizes the possibility
of electric shock hazard . If the wall outlet you plan to
use is only a 2-prong outlet, it is your responsibility to
have it replaced with a properly grounded 3-prong wall
outlet .
Some models require 230/208-volt AC,
protected with a time-delay fuse or circuit
breaker . These models should be installed on
their own single branch circuit for best
performance and to prevent overloading
house or apartment wiring circuits, which
could cause a possible fire hazard from
overheating wires .
Air Conditioner
CAuTion:
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
Do not change the plug on the power cord
of this air conditioner.
Aluminum house wiring may present special
problems—consult a qualified electrician.
TooLS You WiLL neeD
Phillips-head screwdriver
Flat-blade screwdriver
Pencil
Level
Power cord includes a current interrupter device . A
test and reset button is provided on the plug case . The
device should be tested on a periodic basis by first
pressing the TeST button and then the ReSeT button
while plugged into the outlet . If the TeST button does
not trip or if the ReSeT button will not stay engaged,
discontinue use of the air conditioner and contact a
qualified service technician .
7
Ruler or tape measure
Scissors or knife