Pelgrim KB 7224/2 Notice D'utilisation page 15

Fasten the appliance to the floor of the
cupboard by screwing two screws through the
holes in the bottom hinge holders (fig. 3b).
Fasten the appliance to the roof of the
cupboard by screwing two screws through the
decorative frame.
fig. 3b
fitting the doors
Open the kitchen cupboard and fridge/freezer
doors.
First fit the brackets (fig. 4-E) to the
fridge/freezer door with the flat side against
the door.
E
fig. 4
Open the kitchen cupboard and fridge/freezer
doors as far as possible.
Slide the door guides (fig. 5-F) into the
brackets E with the three screw holes towards
the outside of the fridge/freezer door.
fig. 5
Determine the position of the fixing holes for
the door guides F. The door guides should be
fitted at a distance of 25 mm from the edge of
the cupboard door.
Fix the door guides F to the cupboard door.
Screw the door guides in place with the wood
screws and stick the cover plates to the door
guides.
changing the direction in which the
fridge/freezer doors open
Using a knife or other sharp object, carefully
remove the cap from the top left of the
refrigerator door. Then remove the cap from the
bottom left of the refrigerator door.
Do the same with the door of the freezer
compartment.
Close the fridge/freezer doors.
please note:
Now take a firm hold of the fridge/freezer
doors.
At the side of the fridge/freezer, first unscrew
the top locking screw S (fig. 6) on the hinged
F
side of the freezer compartment door.
fig. 6
Using the screwdriver, slide the top locking
screw upwards. Then tighten the screw again.
Hinge pen T is now completely in the hinge
holder. Put the plastic ring that was on the top
hinge pen to one side.
Lift the freezer door off the body.
Unscrew the bottom locking screw S while
holding the refrigerator door. Using the
screwdriver, push the screw downwards and
then tighten the locking screw again.
Lift the refrigerator door off the appliance.
Put the plastic ring that was on the bottom
hinge pen to one side.
Carefully lay the doors on a scratch-free
surface.
Move the plastic guides for the hinge pen to
the left side of the door.
Unscrew the two screws from the metal
hinges between the doors and fit the hinge
bracket on the left side.
Put the caps into the holes which have been
S
left on the right side.
T
Unscrew the locking screw S on the left side
and lift the hinge pen at the bottom left up a
little. Tighten the locking screw again and put
the plastic ring on the hinge pen.
T
S
Lift the refrigerator door up and place it at the
correct position on the left hinge pen.
Unscrew the locking screw again and lift the
bottom hinge pen up further with the
screwdriver and then tighten the locking
screw again.
Unscrew the locking screw at the top left and
push the top hinge pen down a bit. Slide the
plastic ring onto the pen.
Place the freezer door onto the body.
Push the hinge pen all the way down and
tighten the locking screw again.