Whirlpool W10417737A Guide D'utilisation Et D'entretien page 13

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/help
If you experience
Water Leaks
Water or suds leaking Door opened during "Add a
Garment."
from door or rear of
cabinet (cont.)
Residue on door glass.
Washer not performing as expected
Load not completely Water level not visible on door or
covered in water does not cover clothes.
Washer won't run Check for proper water supply.
or fill, washer stops
working
If you experience
Washer not performing as expected (cont.)
Washer won't run
Check proper electrical supply.
or fill, washer stops
working (cont.)
for assistance and to possibly avoid a service call.
Possible Causes
Possible Causes
Normal washer operation.
Water can drip off the inside of the door when the door is
opened after the start of a cycle.
Periodically clean the underside of the glass window to avoid
potential leaks.
This is normal for an HE front load washer. The washer senses load
sizes and adds the correct amount of water for optimal cleaning.
Both hoses must be attached and have water flowing to
inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Check electrical source or call an electrician to check if voltage
is low.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Door must be completely closed and latched for washer to run.
Press and hold START/PAUSE for 1 second.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
The washer pauses for about 2 minutes during certain cycles.
Allow the cycle to continue. Some cycles feature periods of
tumbling and soak.
Washer may be stopped to reduce suds.
Solution
Solution
13