Electrolux ST246F Notice D'utilisation page 83

Problem
Water flows on the rear
plate of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clog‐
ged.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The Super Freeze function
is switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
ENGLISH
Solution
Set a higher temperature.
Refer to "Operation" chap‐
ter.
This is correct. Dry the wa‐
ter with a soft cloth.
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable
packaging before storing it
in the appliance.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water
outlet to the evaporative
tray.
Switch off Super Freeze
function manually, or wait
until the function deacti‐
vates automatically to set
the temperature. Refer to
"Super Freeze function"
section.
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
83