Atag WS9074MN Mode D'emploi page 46

MAINTENANCE
EN 10
Removing cassette filter
1 Switch off the motor and lighting.
2 Push in the locking lugs at the front behind the glass plate and
pull the glass plate carefully out of the seal. Tilt the glass plate
downwards.
3 Open the filter's access hatch.
4 Remove the filter from the hood.
Cleaning
The filters can be cleaned in the dishwasher. Allow the filters to drain
well before replacing.
The filters can also be cleaned by hand.
Clean the filters in soapy water with washing up liquid and rinse. Allow
the filters to drain well. See page 9 for instructions. The underside of
the cooker hood can be cleaned with a mild cleaning agent and a damp
cloth. Dry off with a paper towel.
Replacing cassette filter
The filter should be placed with the locking mechanism on the front.
Open the filter access hatch. The notches at the front of the filter will then
slot in. Hold the access hatch in this position when placing the filters.
1 Slot the notches at the back of the filter in the specially designed
opening of the cooker hood.
2 Tilt the filter upwards.
3 Release the filter access hatch. The notches at the back of the
filter will extend outwards and slot into the specially designed
openings of the cooker hood.
The filter is now in position again.
4 Press the glass plate firmly in the seal again (you will hear a click).
The glass plate can be removed for cleaning. Always remove the
glass plate with 2 persons (due to its weight)!