Facom CL3.CC18SD Notice Originale page 22

Proper Hand Position (Fig. 4)
WARNING: To reduce the risk of serious personel injury, ALWAYS use proper hand position as
shown.
WARNING: To reduce the risk of serious personel injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the main handle (G).
Worklight (Fig. 5)
There is a worklight (E) located above the trigger switch (A). The
worklight is activated when the trigger switch is depressed, and will
automatically turn off 20 seconds after the trigger switch is released. If
the trigger switch remains deperessed, the worklight will remain on.
NOTE: The worklight is for lighting the immediate work surface and is
not intended to be used as a flashlight.
Anvil with Hog Ring (Fig. 6)
WARNING: Use only impact sockets. Non-impact sockets may break and cause a
hazardous condition. Inspect sock et prior to use to ensure that it con tains no cracks.
Place the forward/reverse button (B) in the locked off (cente) position or remove battery
pack before changing accessories.
To install a socket on the hog ring anvil, firmly push socket onto the anvil (F). The hog
ring (K) compresses to allow the socket to slide on. After the socket is installed, the hog ring
applies pressure to help provide socket retention.
To remove a socket, grasp the socket and firmly pull it off.
CAUTION: Inspect anvils and hog rings prior to use. Missing or damaged items should
be replaced before use.
Square Drive
Voltage VDC 18
Type
Battery Type
No load speed
Max Torque N.m
Weight (without battery pack) kg
Noise values and vibration values (triax vector sum) according to EN60745-2-2
LPA (emission sound pressure level) dB(A)
LWA (sound power level) dB(A)
KWA (uncertainty for the given sound level) dB(A)
Tightening of fasteners at the maximum capacity of the tool
Vibration emission value ah = m/s2
Uncertainty K = m/s2
NU-CL3.CC18S_0316.indd 22
5
E
TECHNICAL DATA
CL3.CC18SD
1/2
10,8V
1
Li-Ion
0-2000
508
1,2
90
101
3
24
5,1
22
4
6
F
K
3/30/2016 10:14:28 AM
G