Metabo TP 6600 Instructions D'utilisation Originales page 12

ENGLISH
B
Danger! Risk of electric shock!
Do not touch the plug with wet hands! To un-
plug always pull on the plug, not the power
cable.
Connect only to an earthed outlet that is
properly installed, earthed and tested. Mains
voltage and fuse protection must correspond
to those stated in the 'Technical Specifica-
tions'.
Always lift and transport the pump by the
handle, never by the power cable or dis-
charge hose.
Extension cables must have sufficient con-
ductor cross sections. Unroll cable reels ful-
ly.
Do not buckle, squeeze, drag or drive over
power cable or extension cables; protect
from sharp edges, oil and heat.
Place extension cable so that it can not get
into the fluid to be pumped.
Always unplug before servicing the pump.
B
Risk of electric shock from pump
faults!
Before each use check the equipment, espe-
cially the power and extension cables, power
plug and float switch for possible damage.
Risk of fatal electric shock!
Do not attempt to repair the pump yourself!
When repaired inexpertly there is a hazard of
liquid entering the electrical parts of the
pump.
A
Caution!
To avoid water damage, e.g. flooded
rooms, caused by pump malfunctions or
defects:
provide for suitable safety measures such

as the following:
– alarm or
– collection tank with monitoring.
The manufacturer is not liable for any dam-
age caused by:
– improper use of the pump;
– overloading of the pump through conti-
nous operation;
– failure to operate and store the pump in a
frost-free environment;
– unauthorised modification of the pump (re-
pairs to electrical equipment may only be
carried out by qualified electricians!);
12
– use of spare parts which have not been
tested and approved by the manufacturer;
or
– use of unsuitable installation materials (fit-
tings, connection lines etc.).
Suitable installation materials:
– pressure-resistant (min. 10 bar)
– heat-resistant (min. 100°C).
4. Assembly and Installation
4.1 Assembling the handle / lift-
ing eye
9
10
13
1. Bring the two halves of the handle (10) to-
gether as illustrated above.
Run the power supply cable (11) and float
switch cable (12) out the top.
2. Join the two halves of the handle (10). En-
sure that the guides on the two handle
parts engage.
3. Secure the handle with the four screws (9)
to the pump casing (13). Use the supplied
screws only.
4.2 Connecting the discharge line
G 1"
1¼"
14
1½"
15
16
PS 18000 SN
11 12
10
14
1"
G 1"
1¼"
15
16
All other models