Facom CL3.R10J Notice Originale page 17

• Air vents often cover moving parts and should be avoided. Loose clothes, jewelry or long hair can be caught in moving
parts.
Residual Risks
In spite of the application of the relevant safety regulations and the implementation of safety devices, certain residual risks cannot be
avoided. These are :
- Impairment of hearing.
- Risk of personal injury due flying particles;
- Risk of burns due to accessories becoming hot during operation.
- Risk of personal injury due to prolonged use.
WARNING: ALWAYS use safety glasses. Everyday eyeglasses are NOT safety glasses. Also use face or dust mask if cutting operation is
dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known
to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out
microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay
on the skin may promote absorption of harmful chemicals.
CAUTION: When not in use, place tool on its side on a stable surface where it will not cause a tripping or falling hazard. Some tools with
large battery packs will stand upright on the battery pack but may be easily knocked over.
• The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V volts
Hz hertz
min minutes
direct current
Class I Construction (grounded)
Class II Construction (double insulated)
.../min per minute
IPM impacts per minute
A amperes
Important Safety Instructions for All Battery Packs
When ordering replacement battery packs, be sure to include catalog number and voltage. The battery pack is not fully charged out of the
carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.
• Do not charge or use the battery pack in explosive atmospheres, such as in the presence of flammable liquids,
gases or dust. Inserting or removing the battery pack from the charger may ignite the dust or fumes.
• NEVER force the battery pack into charger. DO NOT modify battery pack in any way to fit into a non-compatible
charger as battery pack may rupture causing serious personal injury.
NU-CL3.R10J R10R_0216.indd 17
W
no
RPM
BPM
READ ALL INSTRUCTIONS
17
watts
alternating current
alternating or direct current
no load speed
earthing terminal
safety alert symbol
revolutions per minute
beats per minute
2/26/2016 3:06:20 PM