Battery Installation; Ed Backlight Warning System; Lcd Screen Functions - XciteRC XRC 6Si Mode D'emploi

Getting started

Battery Installation

4xAA batteries are required to operate the transmitter, the polarities
of which are shown below.
EN
LED backlight warning system
The backlit LCD screen of the transmitter serves also as a warning system. Under normal operating condi-
tions, the LED backlight is solid. If the backlight flashes and there is an audible warning sound, please check
that the following conditions are met on the transmitter:
1.) The transmitter battery voltage is no less than 4 V.
2.) The throttle stick is at its lowest position.
3.) The IDLE switch is set to 0
4.) The Throttle hold (TH.HOLD) switch is set to 0
ä
(1) (2) (3) (4)

LCD screen functions

The icons and what they signify on the LCD screen are indicated below: :
TX Voltage Dual Rates
Stick mode
Electronic trim Electronic trim
Model type
Electronic trim
50501000 Sender XRC 6Si 27