Wiring Diagram And Binding Procedure; Function Keys In Panel; Stick Calibration - XciteRC XRC 6Si Mode D'emploi

Getting started

Wiring diagram and binding procedure

Binding:
Switch on the transmitter, reduce throttle to its lowest position and make sure the alarm is off when powering
on the receiver/aircraft. Press the bind button (if applicable) until the green light turns, solid, signaling binding
success.
Caution:
While binding, place the transmitter and receiver antennas in close proximity if possible; make sure that there
are no similar devices on bind mode within approximately 10 meters. If the light flashes after the binding
procedure is complete, retry the binding procedure again until the light turns solid.

Function keys in panel

There are 3 funcfion keys on the panel, Details below:

Stick calibration

Center both control columns,simultaneously hold the throttle trim up and the rudder trim left; turn the trans-
mitter on. The buzzer will sound four times, release all trims and reduce the throttle column to its lowest
position.
á
50501000 Sender XRC 6Si
ã ã
power
Flap servo
undercarriage servo
Rudder servo
Throttle servo
Elevator servo
Aileron servo
UP
DOWN
SELECT
ä
50501000 Sender XRC 6Si
EN
25