Connectors - LD Systems STINGER G3 Série Manuel D'utilisation

All Stinger G3 enclosures are made of rigid, low-resonance birch ply. They are coated with non-abrasive, impact resistant
®
polyurea for superior strength and unrivaled durability. Integrating LD Systems' Dual-Tilt pole mount, multiple suspension
points, stacking recesses and ergonomic handles the Stinger
companies and installation applications. The large selection of Stinger
hardware plus a stackable dolly board to facilitate transport. Isn't it time you saddled up?

CONNECTORS

1
MAIN INPUT
Input with Speakon-compatible speaker socket (assignment 1+, 1- = internal loudspeaker chassis). The INPUT and OUTPUT sockets are
wired in parallel (1+, 1- & 2+, 2-). The speaker has an impedance of 8 ohms.
2
OUTPUT THRU
Output with Speakon-compatible speaker socket (assignment 1+, 1- & 2+, 2-). When routing the signal, please be aware of the total impedance
of the system to prevent any damage to the amplifier.
3
CH 2 OUTPUT
Special output for controlling a Mid/Hi speaker when using a 4-wire cable, in which the subwoofer signal is fed to 1+ and 1- and the Mid/Hi
signal to 2 + and 2 -. The contacts 2+ and 2- of the MAIN INPUT socket are wired to the contacts 1+ and 1- of the CH 2 OUTPUT socket in
order to enable controlling a Mid/Hi speaker with a 2-core cable with 1+ and 1- assignment.
NOTE: The passive subwoofers of the Stinger G3 Series do not have an internal crossover, therefore the use of an active crossover, or a DSP
amplifier is mandatory.
G3 Series has been designed for touring musicians, rental
®
accessories includes smart wall and truss mounting
®
3
1 2
5