Panel Tv; Sr+ Setup For Pioneer Flat Panel; Tvs; Switching On The Sr+ Mode - Pioneer HTZ-575DV Mode D'emploi

Other connections
Pioneer flat

panel TV

OPTICAL
LINE 1
MCACC
DIGITAL IN
SETUP MIC
Important
• With an SR+ cable connected, the remote
must now be pointed towards your flat
panel TV rather than the remote sensor of
this unit in order to control this system.
• Use a 3-ringed miniplug SR+ cable to
connect the CONTROL IN jack of this unit
through a media receiver to the CONTROL
OUT jack of your flat panel TV.
Before you can use the extra SR+ features, you
need to make a few settings in the unit. See
SR+ Setup for Pioneer Flat Panel TVs below for
detailed instructions.
SR+ Setup for Pioneer Flat Panel TVs
Make the following settings if you have
connected a Pioneer flat panel TV to this unit
using an SR+ cable. Note that the number of
video inputs available will depend on the flat
panel TV you've connected.
1 Press SHIFT+SR+ on the remote.
Use the / to select SETUP, then
2
press ENTER.
Note
1 You won't be able to use the remote sensor of this unit with the CONTROL IN jack of this unit connected to the CONTROL OUT
jack of your flat panel TV. You can use the remote sensor of the flat panel TV (even in standby) as long as the power isn't switched
off.
2 The PDP5 input may be called 'PC Input' (or similar) on your flat panel TV.
To control
output
P
COMPONENT R
VIDEO
P
B
VIDEO
IN
Y
CONTROL VIDEO OUT
1
Use / to select the setting you want.
3
• VOL.C OFF – This unit does not control the
volume of the flat panel TV.
• VOL.C ON – When this unit is switched to
one of the inputs that use the flat panel TV
(DVD, or another one of functions below),
the volume on the flat panel TV is muted so
only sound from this system is heard.
4 Assign any input source connected to the
flat panel TV to the corresponding input
number.
Use / to select the source (DVD, LN1/2
(LINE 1/2) or USB), then / to select the
input number.
This matches this unit's input source with a
numbered video input on the flat panel TV.
example, select the LN1 PDP3 or LN2 PDP3
setting if the video output of your line
component is connected to video input 3 on
the flat panel TV. TVTN switches the flat panel
TV to its built-in tuner and NONE leaves the flat
panel TV input as is (no switching takes place).
5 When you're finished, press ENTER.

Switching on the SR+ mode

1 Press SHIFT+SR+ on the remote.
Use / to select SR+ ON then press
2
ENTER.
To switch SR+ control off, select SR+ OFF.
• If you disconnect the SR+ cable or switch
the flat panel TV off while SR+ is on, the
SR+ ON setting remains.
• The SR+ setting is maintained even after
switching this system into standby then
back on. Automatic muting will be effective
when this system is switched on.
09
2
For
37
En