Installation - PRESIDENT JOHNNY III Manuel D'utilisation

Welcome to the world of the new generation of CB radios. The new PRESIDENT
range gives you access to top performance CB equipment. With the use
of up-to-date technology, which guarantees unprecedented quality, your
PRESIDENT JOHNNY III ASC 12/24 V is a new step in personal communication
and is the surest choice for the most demanding of professional CB radio
users. To ensure that you make the most of all its capacities, we advise you
to read carefully this manual before installing and using your PRESIDENT
JOHNNY III ASC 12/24 V.
A) INSTALLATION
1) WHERE AND HOW TO MOUNT YOUR MOBILE CB RADIO
a) You should choose the most appropriate setting from a simple and practical point
of view.
b) Your CB radio should not interfere with the driver or the passengers.
c) Remember to provide for the passing and protection of different wires (e.g. power,
antenna, accessory cabling) so that they do not in any way interfere with the driving
of the vehicle.
MOUNTING
DIAGRAM
d) To install your equipment, use the cradle (1) and the self-tapping screws (2) provided
(drilling diameter 3.2 mm). Take care not to damage the vehicle's electrical system
while drilling the dash board.
e) Do not forget to insert the rubber joints (3) between the CB and its support as these
have a shock-absorbing effect which permits gentle orientation and tightening of
the set.
f) Choose where to place the microphone support and remember that the microphone
cord must stretch to the driver without interfering with the controls of the vehicle.
N.B. : As the transceiver has a frontal microphone socket, it can be set into the dash
-
board. In this case, you will need to add an external loud speaker to improve the
sound quality of communications (connector EXT.SP situated on the back panel: D).
Ask your dealer for advice on mounting your CB radio.
29