PRESIDENT JOHNNY III ASC Manuel D'utilisation page 34

3) DISPLAY
It shows all functions:
The BARGRAPH shows the reception level and the output power level.
4) RF GAIN
Adjustment of the sensitivity during reception. For long distance communications
RF GAIN should be set to maximum. You can reduce the RF GAIN in order to avoid
distortion when your correspondent is close by and when he has no RF POWER.
The normal setting of this function is on maximum (fully clockwise).
5) CHANNEL SELECTOR: Rotary Knob
This button allow increasing or decreasing a channel. A «beep» sounds each time
the channel changes if the KEY BP function is activated. See KEY BP function.
6) F ~ KEY BP
F - FREQUENCY BAND SELECTION
(confi guration: E; d; EU; PL)
The frequency bands have to be chosen according to the country of use. Don't use
any other confi guration. Some countries need a user's licence.
See the confi gurations/ frequency bands table at page 53.
Proceeding: switch off the transceiver. Keep the key F pressed and switch on again.
and the letter corresponding to the confi guration are blinking.
- In order to change the confi guration, use the channel selector on the front panel.
- When the confi guration is selected, press 1 second on the F key.
corresponding to the confi guration are continuously displayed, a beep sounds. At
this point, confi rm the selection by switching off the transceiver and then switching
it on again.
See table page 53.
KEY BP
Beep on changing the channel, keys etc... (long press)
Activate the KEY BP function by pressing 1 second the KEY BP key. A beep sounds
and «BP» is displayed. In order to disable the function, press during 1 second the KEY
BP key. «BP» disappears.
7) VOX ~ VOX SET
VOX
(short press)
The VOX function allows transmitting by speaking into the original microphone (or in
the optional vox microphone) without pressing the PTT switch. The use of an optional
vox mike connected to the rear panel of the transceiver (C) disables the original
microphone.
Press shortly the VOX key in order to activate the VOX function. «VOX» appears on
the display. A new press on the VOX key disables the function «VOX» disappears.
VOX SET
(long press)
Press during 1 second the VOX key in order to activate the functionVox adjustment.
Three adjustments are possible: Sensitivity / Anti-vox level
shortly the VOX key in order to go to the following adjustment (looping , , ).
The display shows the type of adjustment followed by its level.
34
and the letter
/ Vox delay time . Press