Exercising; Count Up; Count Down; Target Range - Kettler SDIR Mode D'emploi

26

Exercising

The computer has 12 resident exercising programs.
They all differ significantly from one another in the intensity
and duration of the resistance required.
1. Exercising by resistance settings
a) Manual input of resistance setting
• (PROGRAM) "Count Up"
• (PROGRAM) "Count Down"
b) Resistance profile
• (PROGRAM) "1" – "6"
2. Exercising by pulse-rate settings
a) Manual input of pulse setting
• (PROGRAM) "HRC1 Count Up"
• (PROGRAM) "HRC2 Count Down"
b) Pulse profile
• (PROGRAM) "HRC3"
• (PROGRAM) "HRC4 "
Exercising by resistance settings
a) Manual input of resistance setting
(PROGRAM) "Count Up"
• Press "PROGRAM" until: Display:
At start of exercising, all figures count forwards.
or
• Press "SET": Setting zone
• "Plus" or "Minus": adjust resistance. At start of
exercising, all figures count forwards.
(PROGRAM) "Count Down"
• Press "PROGRAM" until: Display:
The program counts from set values backwards > 0.
If no setting is made, exercising starts with program

"Count up".

At start of program, there must be at least one setting
in the setting zone.
• Press "SET": Setting zone
Setting zone
Display: Oar-stroke setting "Str"
Oar-stroke setting
• Enter values with "Plus" or "Minus" (e.g. 900).
Confirm with "SET"
Display:
next menu Stroke-number setting "St./min"
Stroke-number setting
• Enter values with "Plus" or "Minus" (e.g. 30).
Confirm with "SET"
Display: next menu Signal output "Beep"

Signal output

"Beep off" – no acoustic stroke aid
"Beep 1x" – 1 signal for whole stroke
"Beep 2x" – 1 signal for / oar stroke
1
2
• Enter values with "Plus" or "Minus" (e.g. 1x)
Confirm with "SET"
Display: next menu Time setting "TIME"
"Count Up".

"Count Down"