Publicité
Les langues disponibles
Les langues disponibles
User instructions
Position the appliance as indicated at "Best place for
fixing". Put the plug into the socket. The fluorescent
tube should light now. After some time the drawer of
the Electronic Fly Trap will become full and should
In the packing you will find the following parts
• The appliance complete with tubes and drawer
• A chain to hang the appliance
Best place for fixing
• Away from windows or doors because of draft and
daylight.
• Away from places where food will be prepared or
presented.
• Close to the area where flies come in but away
from draft and wind.
• Somewhere the appliance can stay 24 hours a day.
Replacement of tubes and starters
Remove the plug from the socket. Remove the
screws at the bottom of the housing (Figure 2) and
the outer grid upper screws and remove it (Figure
3). The outer grid consists of two parts, therefore it
is sufficient to remove the screws on one side only
from the fluorescent lamp and not on the inner side
of the grid. Turn the lamp 90 ° and remove the han-
Preparations before using for the first time
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Clean the appliance with luke-warm water and a
soft cloth.
Cleaning and maintenance
• Always remove the plug from the socket before
cleaning the appliance.
• Beware: Never immerse the appliance in water or
any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• Never use aggressive cleaning agents or abra-
be emptied. Remove the plug from the socket and
remove the drawer (fig.8) to empty it. Suitable for a
room with an area of 60m
/ 150m
(270172) maximum.
2
• The user manual
• Above eye level and so that no one can bump the
appliance.
• Out of reach from flammable objects like curtains,
lace curtains etc.
• Away from flammable liquids or gases. DANGER
OF EXPLOSION
• This appliance can stand as well as hang by the
included chain (fig.1)
dle (figure 4). Place the new lamp in the reverse
order of its removal. Almost equal operations to be
carried out in order to exchange starters (Fig.5 and
6). After replacing the lamp and / or starters retight-
en the outer grid. Do not turn on and do not use
without a grid - danger of electric shock.
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
sives. Do not use any sharp or pointed objects. Do
not use petrol or solvents! Clean with a damp cloth
and detergent if necessary. Do not use abrasive
materials.
• Clean the ventilation slots (if applicable) with the
vacuum cleaner.
(270158) / 100m
(270165)
2
2
EN
5
Publicité
