Hitachi CR 13V Mode D'emploi Et Instructions De Securite page 13

8. Adjusting the base
(1) Lift the front cover up as illustrated in Fig. 12.
(2) If a base setting screw is loosened with an
attached allen wrench, you can adjust a base
installing position. (Fig. 13, Fig. 14)
Base
Set Screw
12 mm
(3) After adjusting the base installing position,
tighten the base setting screw with the attached
allen wrench completely.
9. Adjusting the blade reciprocating speed
This unit has a built-in electronic control circuit that
makes it possible to adjust the variable speed of the
saw blade by pulling the switching trigger. (Fig. 15)
If you pull the trigger further in, the speed of the
blade accelerates. Begin cutting at a low speed to
ensure the accuracy of your target cut position. Once
you've obtained a sufficient cutting depth, increase
the cutting speed.
CAUTION:
Although this unit employs a powerful motor, prolonged use at a low speed will increase
the load unduly and may lead to overheating. Properly adjust the saw blade to allow
steady, smooth cutting operation, avoiding any unreasonable use such as sudden stops
during cutting operation.
Allen Wrench
Fig. 13
Base
Front Cover
Base
Fig. 14
English
Fig. 12
Switch
Trigger
Fig. 15
13