Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
CAUTION:
Never touch the saw blade immediately after use. The metal is hot and can easily
burn your skin.
WHEN THE BLADE IS BROKEN
Even when the saw blade is broken and remains inside the small slit of the plunger, it
should fall out if you push the lever in the direction of the arrow mark, and face the
blade downward. If it doesn't fall out itself, take it out using the procedures explained
below.
(1) If a part of the broken saw blade is sticking out
of the small slit of the plunger, pull out the
protruding part and take the blade out.
(2) If the broken saw blade is hidden inside the small
slit, hook the broken blade using a tip of another
saw blade and take it out. (Fig. 8)
MAINTENANCE AND INSPECTION OF SAW
BLADE MOUNT
(1) After use, blow away sawdust, earth, sand,
moisture, etc., with air or brush them away with
a brush, etc., to ensure that the blade mount
can function smoothly.
(2) As shown in Fig. 9, carry out lubrication around
the blade holder on a periodic basis by use of
cutting fluid, etc.
NOTE:
Continued use of the tool without cleaning and
lubricating the area where the saw blade is
installed can result in some slack movement of
the lever due to accumulated sawdust and chips.
Under the circumstances, pull a rubber cap
provided on the lever in the direction of an arrow
mark as shown in Fig. 10 and remove the rubber
cap from the lever. Then, clean up the inside of
the blade holder with air and the like and carry
out sufficient lubrication.
The rubber cap can be fitted on if it is pressed
firmly onto the lever. At this time, make certain
that there exists no clearance between the blade
holder and the rubber cap, and furthermore
ensure that the saw-blade-installed area can
function smoothly.
CAUTION:
Do not use any saw blade with a worn-out blade
hole. Otherwise, the saw blade can come off,
resulting in personal injury. (Fig. 11)
12
Lever
Another Blade
Slit of
Plunger
Fig. 8
Blade Holder
Lever
Fig. 9
Lever
Rubber Cap
Fig. 10
Blade
Fig. 11
Machine
Oil
Blade Hole
Publicité
Table des Matières
