Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Hex wrench storage
2
► 1. Grip 2. Hex wrench
Hex wrench is stored on the tool. To remove hex
wrench, rotate it toward yourself and pull it out.
To install hex wrench, place it on the grip and turn it until
it comes into contact with the protrusion on the grip.
Removing or installing saw blade
1
► 1. Shaft lock 2. Hex wrench
CAUTION:
•
Be sure the blade is installed with teeth pointing
up at the front of the tool.
•
Use only the Makita hex wrench to install or
remove the blade.
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the hex wrench to loosen
the hex bolt clockwise. Then remove the hex bolt, outer
flange and blade.
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
COUNTERCLOCKWISE SECURELY.
1
2
1
3
► 1. Ring 17 2. Inner flange 3. Saw blade 4. Outer
flange 5. Hex bolt
When changing blade, make sure to also clean the
upper and lower blade guards of accumulated sawdust
as discussed in the Maintenance section. Such efforts
do not replace the need to check lower guard operation
before each use.
CAUTION:
•
One side of the inner flange is for 5/8" hole
diameter of the blade and the other side is for
13/16" hole diameter. Use the correct side for
the hole diameter of the blade you intend to use.
Mounting the blade on the wrong side can result
in dangerous vibration.
1
► 1. Ring 17 2. Inner flange 3. Blade 4. Outer flange
2
5. Hex bolt 6. Mounting shaft
OPERATION
CAUTION:
•
Be sure to move the tool forward in a straight
line gently. Forcing or twisting the tool will result
in overheating the motor and dangerous kick-
back, possibly causing severe injury.
7 ENGLISH
4
3
2
6
5
4
5
Publicité
