Clock Adjustment; How To Access The Programming Mode; Key Menu - Coffee Selection - La Cimbali M39 GT Dosatron Utilisation Et Installation

Use the "+" (30) and "-" (31) keys to adjust the clock.
The time increases (or decreases) one minute each time the
key is pressed.
If one of the keys (30 or 31) is pressed and held down for more
than 10 seconds, the minutes setting stops and the hours
setting increases (or decreases).
During the time setting phase, the seconds remain at "00".
Note. ONLY if the item "Customer Progr." is set on "YES"
and the item "Program. block" is set on "NO".
To access programming press the PRG (29) key; the following
message will appear on the display:
 CUSTOMER PROG.
KEY MENU
Press one of the dispensing keys on the selection panel (2);
the relative led will remain on.
Use the "+" (30) and "-" (31) keys to position the cursor (black
line) on the desired line, then press the PRG (29) key.
Always use the "+" (30) and "-" (31) keys to change the setting;
at this point there are two possibilities:
1) confirm the changes made by pressing the OK key
2) exit the menu and leave the settings unchanged by pressing
the RES key
Press one of the coffee dispensing keys on the selection panel
(2) (the relative led will remain on, not flashing). The following
message will appear on the display:
 KEY MENU
Type
Water dose
Each dispensing unit is controlled by a panel that permits
programing the amount of desired dispensing for each
button.
The following coffee selection parameters can be modified:
- water dose (volumetric dosage pulses)

15. Clock adjustment

16. How to access the programming mode

+ 

17. Key menu - Coffee selection

+ 
110
22
wednesday
88.6°C
Note: When modifying data, the cursor changes to " ", or a
slide bar with maximum and minimum settings will appear:
If the "Customer Progr." is set to "NO", the following message
will appear on the display:
2
45
April 2009
15:15:04
89.4°C 91.4°C
CUSTOMER PROG.
NOT ENABLED!