Getting Started; Canceling The Display Demonstration; Setting The Demonstration Mode - Kenwood KDC-X396 Mode D'emploi

Remote
Main unit
controller
SCRL DISP —
iPod —
—
— AUD
— ATT
EXIT

Getting started

Canceling the display demonstration

The display demonstration is always turned on unless you cancel it.
When you turn on the power (or after you reset the unit), the display shows:
[CANCEL DEMO] \ [PRESS] \ [VOLUME KNOB]
1 Press the volume knob.
[YES] is selected as the initial setup.
2 Press the volume knob again to confirm.
[DEMO OFF] appears.
If no operation is done for about 15 seconds or if you turn the volume knob to select [NO] in
step 2, [DEMO MODE] appears and the display demonstration starts.

Setting the demonstration mode

1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select [DEMO MODE], then press to enter.
3 Turn the volume knob to select [ON] or [OFF].
If [ON] is selected, display demonstration starts if no operation is done for about
20 seconds.
4 Hold to finish the procedure.
Changes the display information.
Scrolls the display information if pressed and held.
Enters clock adjustment mode directly (page 8) if pressed and
held while in clock display screen.
For
Selects "iPod" source.
Enters the controlling mode (MODE ON/ MODE OFF) for iPod
playback if pressed and held. (page 12)
For
Selects Random Play. (page 11)
Enters [AUDIO CONTROL] / [AUDIO CTRL] settings directly.
Attenuates the sound.
• To return to the previous level, press the button again.
Returns to the previous item.
Exit from setting mode. (Press and hold
also exit from the setting mode.)
(except for
General operation
:
on the main unit will
)
:
Continued...
7