Laserworld tarm Série Mode D'emploi page 12

Manual: tarm Series
Click on the button with the two arrows to the right to upload the *.ild files to the integ-
rated SD card. The files are copied and saved now.
Be aware that, due to the optimized data structure on the mainboard, the upload of
ILDA files can take a while! (several minutes!)
IMPORTANT: It is not possible to upload any other data than *.ild files to the SD card!
If you wanto to change the microSD card inside the housing, please contact the Laser-
world Service Department.
Due to the huge number of available micro SD cards in the market, it cannot be guaran-
teed that all cards are compatible with the laser systems mainboard. The use of standard
sized (max. 2GB) SD cards instead of high capacity SDHC or XDHC cards is recommended.
It is also possible to copy the existing *.ild files on the SD card to the computer by selec-
ting the files on the right side. Then click on the button with the two arrows to the left.
With the button ‚invert selection' it is possible to select all files with just one click.
The button with the exclamation mark formats the SD card and thus deletes all exisiting
files.
To delete single files, select the very *.ild file and then click on the button with the ‚X' on
it (next to the one with the exklamation mark).
In case they got deleted by accident, the standard files can be downloaded on
https://www.laser-interface.com
b) Stand-Alone Mode / Automatic Mode / Playback Mode
Dip switch setting
switch 1
On (1) / Off (0) 0
In stand-alone mode the ILDA files on the integrated SD card are triggered automatically.
This setting is especially suitable for demo purposes or for fixed laser installations.
The stand alone mode allows for additional advanced features: As standard, the stand
alone mode cycles through the ILDA files on the SD cards and plays the consecutively
and in a general loop.
page 12 / 67
2 3 4
0 0 0
5 6 7
0 1 0
8 9 10
1 0 0