Cable Remote Control (X-1); Part 5. Troubleshooting; Part 6. Maintenance - involight FOG400 Mode D'emploi

4.2 Cable remote control (X-1):

The device is controlled by the cable remote control.
1.
2.
1. Status LED:
Using the status LED, you can quickly see if your fog machine is ready for fogging or heating up.
2. Trigger button:
Press the "FOG" button. The machine generates fog until you release the "FOG" button.

Part 5. Troubleshooting:

If there is too little fog, the pump makes noise, or if there is no fog at all, disconnect the unit immediately from the
power supply. Do not attempt to operate the unit further by pressing the activation button on the remote control, as
this can damage the unit. Check the liquid level, the external fuse and the remote connection, and make sure that
the wall socket is live. If these points are correct and the unit still does not work, contact a service technician.

Part 6. Maintenance:

Regularly check the technical safety of the fogging machine. To damage the connecting leads and the housing.
Strong dust deposits, fog residues and dirt reduce the performance and can lead to failure of the device due to
overheating. For longer storage, it is recommended to run the machine at least every 1 to 3 months. Longer
periods out of service can lead to a significant reduction in the life of the machine. Damage caused by a lack of
cleaning of the device is not covered by the product warranty.
Cleaning.
Disconnect the unit from the mains and allow it to cool completely before cleaning.
For external cleaning, use only a dry, soft cloth, in no case chemicals or water that could run into the unit. Clean
the ventilation openings with a soft brush, cotton swab, a vacuum cleaner or compressed air. Fog machines are
susceptible to clogging due to the thick liquid mist and high evaporation temperature. For this reason, it is
recommended to run a cleaning liquid consisting of 90% distilled water and 10% vinegar after approx. 60 operating
hours.
15