Exemple 3-1 : Exécution De L'utilitaire Setup - Dell EqualLogic PS Série Manuel D'installation Et De Configuration

Masquer les pouces Voir aussi pour EqualLogic PS Série:
Table des Matières

Publicité

Installation et configuration
Exemple 3-1 : Exécution de l'utilitaire setup
Login: grpadmin
Password: xxxxxxxx
Copyright 2001 - 2008 Dell, Inc.
It appears that the storage array has not been configured.
Would you like to configure the array now? (y/n) [n] y
The setup utility establishes the initial network and storage
configuration for a storage array and then configures the array
as a member or a new or existing group of arrays.
For help, enter a question mark (?) at a prompt.
Do you want to proceed (yes | no) [no]? yes
Initializing. This may take several minutes to complete.
Enter the network configuration for the array:
Member name []: member1
Network interface [eth0]: eth0
IP address for network interface []: 192.17.2.41
Netmask [255.255.255.0]:
Default gateway [192.17.2.1]:
Enter the name and IP address of the group that the array will
join.
Group name []: group1
Group IP address []: 192.17.2.20
Searching to see if the group exists. This may take a few
minutes.
The group does not exist or currently cannot be reached. Make sure
you have entered the correct group IP address and group name.
Do you want to create a new group (yes | no) [yes]? yes
Group Name:
Group IP address:
Do you want to use the group settings shown above (yes | no)
[yes]: yes
Password for managing group membership:
Retype password for verification:
Password for the default group administration account:
Retype password for verification:
Saving the configuration ...
Waiting for configuration to become active......Done
Group member member1 now active in the group.
Group group1 has been created with one member.
Use the Group Manager GUI or CLI to set the RAID policy for the
member. You can then create a volume that a host can connect to
using an iSCSI initiator.
group1>
3–6
Welcome to Group Manager
Group Manager Setup Utility
Group Configuration
Configuration du logiciel
group1
192.17.2.20

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Equallogic ps6000Equallogic ps6500

Table des Matières