Energy Saver - Haier PBFS21 Série Guide De L'utilisateur

setting tHe control functions (cont'd)
(11) The water filter indicator setting
When the indicator light of the water filter is lit up, the water filter should be
changed. After the water filter is changed, press and hold the water filter reset
button M for one second. The indicator light of the water filter N will go out.
Caution! When the water filter needs to be changed, please refer to the "water
filter" section.
MUST FLUSH 3.75 GALLONS THROUGH FILTER BEFORE USE
(approximately 5 minutes.)
Note: Our water filters comply with CA. propositions requirements.

(12) Energy Saver

1. The energy saver button is initially set to ON. You can see "ES" on the right
display for 3 seconds when you open the refrigeration doors, then it will turn
back to show the refrigeration temperature.
2. By pressing and holding the "energy saver" button M on the control panel for
5 seconds, you can turn on or off the Energy Saver feature.
3. "ES" will appear only when the Energy Saver in the ON position.
(13) Control Center Display Activation
The Top Refrigerator Control Center:
30 Seconds after adjusting the control center
buttons, the digital screen will go out automatically,
and if you press any button or open any door or
activate the water dispenser, the screen will light
again.
The Dispenser Control Center:
1. The refrigerator is shipped with the LED lighting off.
2. The LED lighting turns on if you press any button, open any door, touch the
paddle to get water, and the lighting will turn off automatically once all doors
closed for 30 seconds.
3. If you want to have the lighting on all the time, press the lock button, the light
will glow, then press Button A and B at the same time and hold 3 seconds. To
deactivate, press Button A and B at the same time and hold for 3 seconds.
ENERGY SAVER
M N
ENERGY SAVER
M
D
(Only applicable to PBFS21** and PRFS25** series)
English
B
A
18