Additional handle Fig.3
For safety reasons, use the demolition
hammer only with the additional handle!
1
The additional handle (4) provides you
safe grip while using the demolition
hammer.
2
The additional handle (4) can be rotated
to any position.
3
Loosen the screw (A).
4
Turn the additional handle (3) to a con-
venient and safe working position and
tighten the screw (A) again.
Switching ON / OFF (Fig. 4)
Switching ON: Press the operating switch
(3).
Switching OFF: Release the operating
switch (3).
Operation-/work
instructions
Caution! For your safety, the machine
must be held only at the two handles (3
and 4, Fig. 1)!
This will avoid the danger of an electric
shock through contact of lines during chis-
elling.
Always keep the chiselling tools sharp.
Note:
•
Work only at low pressure when chisel-
ling.
•
Excessive pressure loads the motor un-
necessarily.
30
GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
•
Sharpen the chisels in time and replace,
if necessary.
Dust/Chip Extraction
Dusts from materials such as lead-contain-
ing coatings, some wood types, minerals
and metal can be harmful to one's health.
Touching or breathing-in the dusts can
cause allergic reactions and/or lead to res-
piratory infections of the user or bystand-
ers.
Certain dusts, such as oak or beech dust,
are considered as carcinogenic, espe-
cially in connection with wood-treatment
additives (chromate, wood preservative).
Materials containing asbestos may only be
worked by specialists.
•
Provide for good ventilation of the work-
ing place.
•
It is recommended to wear a P2 fil-
ter-class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Electrical connection
The electrical motor installed is con-
nected and ready for operation. The
connection complies with the applica-
ble VDE and DIN provisions.
The customer's mains connection as
well as the extension cable used must
also comply with these regulations.
Important information