Craftsman CMXEVCVVJC507P Manuel D'utilisation page 8

ENGLISH
WARNING:
HAPPENS, TURN OFF THE MACHINE,
DISCONNECT FROM POWER SUPPLY,
AND DRAIN THE LIQUID INTO A SUITABLE
RECEPTACLE OR DRAIN. AFTER WET
VACUUMING, TURN THE MACHINE OFF
AND REMOVE PLUG FROM POWER SUPPLY.
EMPTY THE COLLECTION TANK, CLEAN AND
DRY THE INSIDE AND OUTSIDE BEFORE
STORAGE.
NOTICE: The foam wet filter must be removed
after wet vacuuming and the reusable cloth
filter must be installed before dry vacuuming
again.
FOAM WET FILTER INSTALLATION
AND CLEANING:
WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
21. Remove the power head and place in an
upside down position. Follow instructions
to remove the reusable cloth filter on page
7.
22. Carefully slide the foam wet filter
over the filter cage making sure the cage is
completely covered. Fig. 11.
Fig. 11
23. To remove the foam wet filter, place the
removed power head in an upside down
position, and carefully remove the foam
15
wet filter . Fig. 12.
8
WHEN THIS
VERIFY THAT THE
15 down
Fig. 12
24. Use a mild soap and water solution to
wash the foam wet filter
clean water. Fig. 13.
Fig. 13
25. Allow the wet filter to air dry for 24 hours
before installing onto the filter cage.
EMPTYING LIQUID WASTE FROM
THE TANK
WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
26. Disconnect the hose
27. Undo the latches
2
power head from the collection tank
6
. Place power head
surface upside down.
28. After use, empty the collection tank
15
and rinse with
VERIFY THAT THE
11 from the vacuum.
4 and remove the
2
on a soft, clean