Craftsman CMXEVCVVJC507P Manuel D'utilisation page 5

2. Lift the power head
6
tank .
3. Remove the contents from inside the
collection tank 6 ; make sure you have all
contents as listed on page 2.
ASSEMBLY
Caster System Assembly
4. Turn the collection tank upside down and
insert the four casters
the collection tank. The casters
snap into place; verify that they are mounted
correctly. Fig. 1.
Fig. 1
Handle Assembly
5. Insert the handle
on the top of the power head
it with the screws
tighten screws 10 . Fig. 2.
Fig. 2
GENERAL SET UP
6. Your vacuum comes ready for dry vacuum
cleaning. If the reusable cloth filter is not
2
off the collection
5
into the slots on
5
should
9
into the slots located
2
and secure
10 provided. Do not over-
installed, refer to page 7 for installation
instructions.
7. For wet vacuum cleaning, remove the
reusable cloth filter, and install the supplied
foam wet filter. See page 8 for the foam wet
filter installation instructions.
8. Place the power head back on the collection
tank and secure into place using the latches.
9. Insert the larger end of the hose
vacuum port on the collection tank
lock into place. Fig. 3.
Fig. 3
10. Choose the desired accessory
extension wands
end of the hose 11
Fig. 4
11. Plug the power cord into the outlet. Turn
the motor on by flipping the on/off switch
8
to the 'I' ON position and begin
vacuuming. Fig. 5.
Fig. 5
ENGLISH
11
into the
6
and
13
and/or
12 and insert onto the
. Fig. 4.
5