Operating The Appliance; Switching On The Appliance; Switching Off And Disconnecting The Appliance; Setting The Temperature - Siemens KI V Série Notice D'utilisation

1
Operating the
appliance

Switching on the appliance

p l i a n c e O p e r a t i n g t h e a p
Press the # button.
1.
The appliance begins to cool.
Set the required temperature.
2.

~ "Setting the temperature"

on page 27
Operating tips
After the appliance has been
■
switched on, it may take several
hours until the set temperatures
have been reached. Do not put in
any food until the selected
temperature has been reached.
The sides of the housing are partly
■
heated slightly. This prevents
condensation in the area of the door
seal.
If the freezer compartment door
■
cannot be immediately re-opened
after it has been closed, wait until the
resulting low pressure has
equalised.
Switching off and
disconnecting the appliance
Switching off the appliance
Press the # button.
■
The appliance no longer cools.
Disconnecting the appliance
If you do not use the appliance for a
prolonged period:
Press the # button.
1.
The appliance no longer cools.
Pull out the mains plug or switch off
2.
the fuse.
Clean the appliance.
3.
Leave the appliance open.
4.
Operating the appliance en
Setting the temperature
Recommended temperature
Refrigerator compartment:
Refrigerator compartment
Keep pressing the button °C until
■
the display indicates the required
temperature.
Freezer compartment
The temperature in the refrigerator
compartment will affect the temperature
in the freezer compartment. Change the
temperature in the refrigerator
compartment in order to change the
temperature in the freezer compartment.
Temperatures which are set higher in
the refrigerator compartment will
increase temperatures in the freezer
compartment.
Sticker OK
(not all models)
You can use sticker OK to check
whether the temperature in the
refrigerator compartment reaches
+4 °C or lower.
If the sticker does not indicate OK,
gradually reduce temperature.
When the appliance is switched on, it
may take up to 12 hours until the set
temperature is reached.
Correct setting
+4 °C
27