Doro R52 Manuel D'utilisation page 37

Remote Control
This machine can be remotely controlled using the keys of an ordinary tone dialling
telephone. Call up the answering machine and enter the remote code while the
outgoing message is playing. Once the code is accepted, several remote control
commands are available.
Remote Code
This three-digit remote code is required in order to gain access to the remote
functions of the answering machine. The remote code is printed underneath the
machine.
Remote Control
1. Call up the answering machine.
2. While the outgoing message is playing, enter the remote code. If the code is
accepted, you will hear two beeps.
3. Select a remote control command (within 20 seconds) from below.
4. When you have finished accessing the machine replace the handset.
Command
25........................................ Play new messages
2# ....................................... Play all messages
During playback:
3#........................................ Erase single message during playback
6#........................................ Skip to previous message
7#........................................ Skip to next message
8#........................................ Repeat message
##........................................ Stop playback
After playback:
3#........................................ Erase all messages
7#........................................ Record a new outgoing message, to Stop
8#........................................ Record a MEMO, to Stop recording press 8#
9#........................................ Turn the answering machine either On or Off.
Please note!
If the machine doesn't respond correctly to the remote control commands, try pressing the telephone
buttons for a longer or shorter time. In normal cases, the answering machine should react to tones
approximately 0.5 – 1 seconds in length, but longer tones may be necessary in certain telephone
networks. If you do not enter any remote control command, the answering machine will disconnect
after a few seconds.
If you listen to any incoming messages for more than 2 minutes and 40 seconds, you will hear a
tone. Press any key to continue.
www.doro.com
Operation
Function
recording press 7# again.
again.
Three beeps indicate Off – Two beeps indicate
On.
English
37