Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.
Remove the burner from the grill by lifting the burner out.
4.
Use a 6 mm socket and wrench or 6 mm nut driver to
remove the LP brass orifice from the end of gas valve.
The main burner NG orifice is located behind the LP orifice,
so no additional orifice needs to be installed.
A. Main burner orifice
IMPORTANT: Check that the LP orifice is properly
removed inside of the burner opening.
5.
Reinsert the burner and reattach using the cotter clip and
screws previously removed. Repeat the procedure for
each main burner.
6.
Position the igniters so they are 1/8" (3.2 mm) away from
each burner.
Change the Sear Burner Orifice
1.
Use a screwdriver to remove screw from the ignitor pin.
2.
Remove two screws on the rear of the searing burner. Lift
the burner starting from the back, as shown.
A
3.
Use a 6 mm socket wrench or 6 mm nut driver to remove
the orifice.
43
Publicité
Table des Matières
