KitchenAid 1902324 Instructions D'installation Et Guide D'utilisation Et D'entretien page 41

Change Grill Main Burner Valve Orifices
1. Remove the grates and flame tamers.
2. Remove the screw and pin that hold the burner in place.
Set the screw and pin aside.
3. Remove the burner from the grill by lifting the burner out.
4. Use a 6 mm socket and wrench or 6 mm nut driver to
remove the LP brass orifice from the end of gas valve.
The main burner NG orifice is located behind the LP orifice,
so no additional orifice needs to be installed.
A. Main burner orifice
IMPORTANT: Check that the LP orifice is properly
removed inside of the burner opening.
5. Reinsert the burner and reattach using the pin and screw
previously removed. Repeat the procedure for each main
burner.
6. Position the igniters so they are 1/8" (3.2 mm) away from
each burner.
Change the Side Burner Orifice
1. Use a wrench to remove the side burner orifice brass
connector with flex line end to side burner tube.
2. Use 6 mm socket wrench or 6 mm nut driver to remove the
orifice.
3. Replace with the Natural gas orifice.
A
IMPORTANT: Check that the NG orifice is properly
installed inside of the valve.
41